Reassembly

AXLE: FRONT AXLE HUB: REASSEMBLY

REASSEMBLY





1. INSTALL FRONT AXLE HUB BEARING
(a) Using SST and a press, insert a new hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.
SST: 09950-60020
09951-00710
SST: 09950-70010
09951-07100
NOTICE:
- Do not remove the inner race because the hub bearing is built into the oil seal.
- Do not use bearings that have been removed.
- Do not wipe off any grease that has been applied to new bearings.
- Do not bring magnets close to the magnetic rotor surface of the bearing.
- Keep the magnetic rotor surface of the bearing free of foreign matter.

2. INSTALL FRONT DISC BRAKE DUST COVER





(a) Provisionally install a new disc brake dust cover, as shown in the illustration.





(b) Using SST and a hammer, install the disc brake dust cover.
SST: 09223-56010
NOTICE:
- Uniformly press in the disc brake dust cover while sliding SST slightly.
- Surely press in the disc brake dust cover until the pressing-in base.





(c) Using a chisel, fix the 3 points on the circumference.
NOTE: Securely fold each end into the engagement grooves.





3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY
(a) Using SST and a press, press the axle hub into the steering knuckle.
SST: 09608-32010
SST: 09950-60010
09951-00500
SST: 09950-70010
09951-07100





4. INSTALL FRONT AXLE HUB HOLE SNAP RING
(a) Using snap ring pliers, install a new hole snap ring, as shown in the illustration.
NOTICE:
- Do not overlap the end of the snap ring and the installation hole in the speed sensor on the knuckle side.
- Do not damage the magnetic rotor surface of the bearing when installing the snap ring.