Differential Case

C50 MANUAL TRANSAXLE: DIFFERENTIAL CASE: INSPECTION

INSPECTION





1. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER
(a) Using a micrometer, measure the thickness of the front differential pinion thrust washer.
Minimum thickness:
0.94 mm (0.0370 in.)
If the thickness is less than the minimum, replace the front differential pinion thrust washer.





2. INSPECT FRONT DIFFERENTIAL PINION SHAFT NO.1
(a) Using a micrometer, measure the outer diameter of front differential pinion shaft No. 1.
Minimum outer diameter:
16.982 mm (0.6685 in.)
If the outer diameter is less than the minimum, replace front differential pinion shaft No. 1.