DTC 58-43

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: 58-43,80-43: SPD Signal Error
80-43 - SPD Signal Error

DESCRIPTION





INSPECTION PROCEDURE

HINT
After the inspection is completed, clear the DTCs.

PROCEDURE

1. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

(a) Enter the "Navigation Check" mode (Vehicle Sensors) Operation Check.





(b) While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

OK:

The readings are almost equal.

NG -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

OK -- REPLACE NAVIGATION RECEIVER ASSEMBLY Removal

2. PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Refer to "Speed signal does not change in the navigation check mode" in Problem Symptoms Table. Symptom Related Diagnostic Procedures

NEXT -- END