Meter / Gauge System

METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: U0100: Lost Communication with ECM / PCM "A"
U0100 - Lost Communication with ECM / PCM "A"

DESCRIPTION

The combination meter communicates with the ECM via the CAN communication line (CAN No. 1 Bus).





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CONFIRM DTC OUTPUT

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Trouble Codes.

(e) Clear the DTCs.

(f) Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

(g) Stop the vehicle.

(h) Check for DTCs Diagnosis System.

Result:





HINT
If the CAN communication system DTC U0100 and other DTCs are output at the same time, perform troubleshooting for DTC U0100 first.

B -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

A -- GO TO CAN COMMUNICATION SYSTEM Initial Inspection and Diagnostic Overview