Tire and Wheel System

TIRE / WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

1. INSPECT TIRES

(a) Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:

for 2WD Models





for 4WD Models





(b) Using a dial indicator, check the runout of the tires.





Maximum tire runout:

1.4 mm (0.0551 in.)

2. ROTATE TIRES

(a) Rotate the tires as shown in the illustration.





3. INSPECT WHEEL BALANCE

(a) Check and adjust the off-the-car balance.

(1) Steel wheel





Maximum imbalance after adjustment:

8.0 g (0.0176 lb)

HINT
If necessary, check and adjust the on-the-car balance.

(2) Others (Non-steel wheel)





Maximum imbalance after adjustment:

8.0 g (0.0176 lb)

NOTICE:
* Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
* Do not touch the adhesive surface of the tape.
* Adhere the sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)

* Push the balance weight securely with a finger to adhere it to the position.
* Do not reuse the balance weight.

HINT
* The inner side balance weight should be installed by clipping it to the rim.
* If necessary, check and adjust the on-the-car balance.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

(a) Inspect the front axle hub bearing looseness .

5. INSPECT REAR AXLE HUB BEARING LOOSENESS (for Torsion Beam Type Suspension)

(a) Inspect the rear axle hub bearing looseness .

6. INSPECT REAR AXLE HUB BEARING LOOSENESS (for Double Wishbone Type Suspension)

(a) Inspect the rear axle hub bearing looseness .

7. INSPECT FRONT AXLE HUB RUNOUT

(a) Inspect the front axle hub runout .

8. INSPECT REAR AXLE HUB RUNOUT (for Torsion Beam Type Suspension)

(a) Inspect the rear axle hub runout .

9. INSPECT REAR AXLE HUB RUNOUT (for Double Wishbone Type Suspension)

(a) Inspect the rear axle hub runout .