Removal

DOOR / HATCH: FUEL LID LOCK CONTROL CABLE ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE FRONT SEAT HEADREST ASSEMBLY

3. REMOVE OUTER SEAT TRACK COVER Removal

4. REMOVE INNER SEAT TRACK COVER Removal

5. REMOVE FRONT SEAT ASSEMBLY Removal

6. REMOVE FRONT DOOR SCUFF PLATE LH Removal

7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH Removal

8. REMOVE REAR DOOR SCUFF PLATE LH Removal

9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal

10. REMOVE LAP BELT OUTER ANCHOR COVER Removal

11. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Removal

12. REMOVE LOWER CENTER PILLAR GARNISH LH Removal

13. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

14. REMOVE REAR SEAT HEADREST ASSEMBLY

15. REMOVE REAR SEATBACK OUTER HINGE COVER Removal

16. REMOVE REAR SEATBACK INNER HINGE COVER Removal

17. REMOVE REAR SEATBACK ASSEMBLY LH Removal

18. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

19. REMOVE DECK BOARD ASSEMBLY Removal

20. REMOVE NO. 2 DECK BOARD Removal

21. REMOVE JACK CARRIER ASSEMBLY

22. REMOVE JACK ASSEMBLY Removal

23. REMOVE DECK FLOOR BOX LH Removal

24. REMOVE DECK FLOOR BOX RH Removal

25. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR Removal

26. REMOVE LUGGAGE COMPARTMENT TRAY Removal

27. REMOVE REAR DECK TRIM COVER Removal

28. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY Removal

29. REMOVE REAR SEAT SIDE GARNISH LH Removal

30. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Removal

31. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY Removal

32. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Removal

33. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH Removal

34. REMOVE SIDE DECK TRIM PANEL ASSEMBLY LH Removal

35. DISCONNECT FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

(a) Remove the bolt.

(b) Disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.

36. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY

(a) Disconnect the fuel lid lock control cable sub-assembly as shown in the illustration.

(b) Disengage the 2 claws and disconnect the fuel lid lock control cable sub-assembly as shown in the illustration.