Removal

2AZ-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: REMOVAL

1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

HINT
* for U250E.
* Removal for U140F.

2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

HINT
for E351.

3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

HINT
for E351.

4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

HINT
for E351.

5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-54015

91651-60855

SST : 09330-00021

(b) Remove the 8 bolts, rear drive plate spacer, drive plate and front drive plate spacer.





6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-54015

91651-60855

SST : 09330-00021

(b) Remove the 8 bolts and flywheel.





7. REMOVE REAR CRANKSHAFT OIL SEAL

(a) Using a knife, cut off the lip of the oil seal.





(b) Using a screwdriver, pry out the oil seal.

NOTICE:
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.

HINT
Tape the screwdriver tip before use.