Installation

2AZ-FE ENGINE MECHANICAL: ENGINE UNIT: INSTALLATION

1. INSTALL RADIO SETTING CONDENSER

(a) Install the condenser with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

2. INSTALL ENGINE COOLANT TEMPERATURE SENSOR Installation

3. INSTALL OIL PRESSURE SWITCH Installation

4. INSTALL KNOCK SENSOR Installation

5. INSTALL IGNITION COIL ASSEMBLY Installation

6. INSTALL NO. 1 WATER BY-PASS PIPE

(a) Install a new gasket and the pipe with the bolt and 2 nuts.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

7. INSTALL ENGINE OIL DIPSTICK GUIDE Installation

8. INSTALL ENGINE OIL DIPSTICK

9. INSTALL THERMOSTAT Installation

10. INSTALL INLET WATER Installation

11. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY Installation

12. INSTALL NO. 2 MANIFOLD STAY Installation

13. INSTALL MANIFOLD STAY Installation

14. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation

15. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR

(a) Install the No. 1 intake manifold insulator onto the cylinder block.





16. INSTALL INTAKE MANIFOLD Installation

17. INSTALL FUEL INJECTOR ASSEMBLY Installation

18. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY Installation