Installation

DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION

1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY

(a) Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.





HINT
Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.

2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY Reassembly

3. INSTALL SOLENOID WIRE (for Automatic Transaxle) Reassembly

4. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle) Reassembly

5. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transaxle) Reassembly

6. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transaxle) Reassembly

7. INSPECT STEERING LOCK OPERATION Testing and Inspection

8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY Reassembly

9. INSTALL STEERING POST ASSEMBLY Installation

10. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

11. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 2WD) Installation

12. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 4WD) Installation

13. INSTALL STOP LIGHT SWITCH ASSEMBLY Installation

14. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY Installation

15. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT Installation

16. INSTALL COLUMN HOLE COVER SILENCER SHEET Installation

17. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) Installation

18. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY Installation

19. INSTALL UPPER STEERING COLUMN COVER Installation

20. INSTALL LOWER STEERING COLUMN COVER Installation

21. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

22. INSTALL NO. 1 SWITCH HOLE BASE Installation

23. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL Installation

24. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Installation

25. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation

26. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation

27. INSTALL FRONT CONSOLE BOX ASSEMBLY

HINT
Refer to the instructions for Installation of the front console box Installation.

28. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

HINT
Refer to the instructions for Installation of the upper instrument panel Installation.

29. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

30. ADJUST SPIRAL CABLE Installation

31. INSTALL STEERING WHEEL ASSEMBLY Installation

32. INSTALL STEERING PAD Installation

33. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

34. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

35. INSPECT STEERING WHEEL CENTER POINT

36. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

37. INSPECT STEERING PAD Installation

38. CALIBRATE TORQUE SENSOR ZERO POINT

HINT
Programming and Relearning.

39. INSPECT SRS WARNING LIGHT

HINT
Diagnosis System.