Installation

2AZ-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.





(b) Install the crankshaft position sensor with the bolt.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
Do not twist the O-ring.

(c) Install the wire harness and crankshaft position sensor connector clamp.

(d) Connect the crankshaft position sensor connector.

2. INSTALL GENERATOR ASSEMBLY Installation

3. INSTALL V-RIBBED BELT Installation

4. INSTALL ENGINE UNDER COVER RH

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. INSPECT FOR OIL LEAK