Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE FRONT SEAT HEADREST ASSEMBLY (w/o Seatback Board)

4. REMOVE OUTER SEAT TRACK COVER (w/o Seatback Board) Removal

5. REMOVE INNER SEAT TRACK COVER (w/o Seatback Board) Removal

6. REMOVE FRONT SEAT ASSEMBLY (w/o Seatback Board) Removal

7. REMOVE FRONT SEAT HEADREST ASSEMBLY (w/ Seatback Board)

8. REMOVE OUTER SEAT TRACK COVER RH (w/ Seatback Board) Removal

9. REMOVE INNER SEAT TRACK COVER RH (w/ Seatback Board)

for 2WD: Removal

for 4WD: Removal

10. REMOVE FRONT SEAT ASSEMBLY RH (w/ Seatback Board) Removal

11. REMOVE RECLINING ADJUSTER RELEASE HANDLE (w/o Seatback Board) Disassembly

12. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (w/o Seatback Board) Disassembly

13. REMOVE VERTICAL ADJUSTING HANDLE (w/o Seatback Board) Disassembly

14. REMOVE FRONT SEAT CUSHION SHIELD (w/o Seatback Board) Disassembly

15. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (w/ Seatback Board) Disassembly

16. REMOVE FRONT SEAT CUSHION SHIELD RH (w/ Seatback Board) Disassembly

17. REMOVE SEAT POSITION SENSOR

(a) Disconnect the connector.





NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.

(b) Using a "TORX" socket wrench (T30), remove the "TORX" screw and seat position sensor with the seat slide position sensor protector.

(c) Remove the seat position sensor from the seat slide position sensor protector as shown in the illustration.