Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

1. INSTALL STEERING KNUCKLE

(a) for 2ZR-FE:

(1) Using SST and a press, install a new front axle hub bearing to the steering knuckle.





SST : 09950-60020

09951-00720

SST : 09950-70010

09951-07100

(b) for 2AZ-FE:

(1) Using SST and a press, install a new front axle hub bearing to the steering knuckle.

SST : 09950-60020

09951-00810

SST : 09950-70010

09951-07100

2. INSTALL FRONT DISC BRAKE DUST COVER Installation

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY Installation

4. INSTALL FRONT AXLE HUB HOLE SNAP RING Installation

5. INSTALL FRONT LOWER BALL JOINT Installation

6. INSTALL FRONT AXLE ASSEMBLY Installation

7. CONNECT FRONT LOWER SUSPENSION ARM Installation

8. CONNECT TIE ROD END SUB-ASSEMBLY (for 2WD) Installation

9. CONNECT TIE ROD END SUB-ASSEMBLY (for 4WD) Installation

10. INSTALL FRONT DISC Installation

11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement

12. TEMPORARILY INSTALL FRONT AXLE SHAFT NUT Installation

13. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Replacement

14. REMOVE FRONT DISC Removal

15. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

16. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

17. INSTALL FRONT DISC Installation

18. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement

19. INSTALL FRONT SPEED SENSOR Installation

20. INSTALL FRONT AXLE SHAFT NUT Installation

21. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT
Front Wheel Alignment

23. CHECK FOR SPEED SENSOR SIGNAL

for 2AZ-FE: Test Mode Procedure

for 2ZR-FE: Test Mode Procedure