Removal

DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REMOVAL

1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(a) Depress the brake pedal and hold it.

(b) Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.





NOTICE:
* Put a piece of cloth or equivalent into the inside of the universal joint cover so that the boot does not touch the inside of the universal joint cover.
* Do not remove the bolts.

(c) Place matchmarks on the rear propeller shaft and the electromagnetic control coupling assembly.





(d) Remove the 4 nuts and 4 washers.

(e) Using a brass bar and a hammer, separate the rear propeller shaft with center bearing shaft assembly.

(f) Remove the 4 bolts and 4 No. 2 center support bearing washers.





NOTICE:
When removing the bolts and washers, do not apply excessive force to the universal joint.

(g) Pull out the propeller with center bearing shaft assembly from the transfer.

NOTICE:
* When removing the propeller shaft, do not apply excessive force to the universal joint.
* During and after the removal of the propeller shaft, keep the universal joint angle straight (within 10 degrees).
* Be careful not to damage the oil seal.

(h) Insert SST into the transfer to prevent oil leakage.





SST : 09325-20010

NOTICE:
Be careful not to damage the oil seal.