Removal
C59 MANUAL TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE BATTERY Removal
3. REMOVE BATTERY TRAY
4. REMOVE BATTERY CARRIER Removal
5. REMOVE NO. 2 CYLINDER HEAD COVER Removal
6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal
7. REMOVE AIR CLEANER CASE Removal
8. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
9. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
(a) Remove the 3 nuts and remove the No. 1 front floor heat insulator.
10. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal
11. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
12. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Removal
13. REMOVE FRONT UPPER CONSOLE BOX Removal
14. REMOVE NO. 2 SWITCH HOLE BASE Removal
15. REMOVE CONSOLE BOX CARPET
16. REMOVE FRONT CONSOLE BOX ASSEMBLY Removal
17. REMOVE FRONT NO. 1 CONSOLE BOX INSERT Removal
18. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal
19. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL Removal
20. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Disconnect the control shift cable from the shift lever assembly.
(b) Disconnect the control select cable from the shift lever assembly.
(c) Using a screwdriver, pull out the stopper of the transmission control cable.
NOTICE:
Do not remove the stopper. If it is removed, reinstall it to its original position.
(d) Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.
NOTICE:
Do not rotate the nut excessively as it will come off the internal spring and the transmission control cable will not be reusable.
(e) Remove the 2 clips and disconnect the 2 transmission control cables from the control cable bracket*1.
(f) Remove the 2 clips and disconnect the 2 transmission control cables from the transaxle*2.
(g) Remove the nut, and disconnect the transmission control cable assembly.
(h) Remove the 2 nuts and transmission control cable assembly.
