Airbag

Airbag

Front Passenger Seat Occupant Sensor (G128)


If Front Passenger Seat Occupied Sensor (G128) is replaced, also the upholstery, front seat cushion must always be replaced!

Removal

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove front seat. Refer to => [ Front Seat ] Front Seats

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove front right seat trim. Refer to => [ Right Seat Trim ] Front Seats

Vehicles with manual seat adjustment

- Remove front left seat trim. Refer to => [ Left Seat Trim ] Front Seats

- Remove bracket and front seat operating lever => [ Front Seat Support And Operating Lever ] Front Seats

Vehicles with electric seat adjustment

- Remove left power seat trim. Refer to => [ Left Power Seat Trim ] Front Seats

- Remove retainer and power seat bracket. Refer to => [ Bracket and Support, Power Seat ] Front Seats

All vehicles

- Remove front seat drawer mount. Refer to => [ Seat Drawer Mount ] Front Seats

• On vehicles with a luggage pass-through, it is sufficient to fold the backrest forward, it does not have to be removed.

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Front Seats

- Remove cover and upholstery from front seat backrests. Refer to => [ Front Seat Pan Covers and Upholstery ] Front Seat Covers and Upholstery


Front Passenger's Seat Occupied Sensor (G128) - 1 - is secured with seat cushion padding. It is not possible to remove and install separately, sensor must be replaced with upholstery.





Installation

- Press wiring harness in positioning aid area - 1 - in rear padding channel.

- Press the wiring harness into the recess in the padding at the areas indicated by the - arrows A and B -.

- Align sensor positioning aid - 3 - with padding positioning aid - 2 -.


Ensure distance from sensor to positioning aids - 2 - is constant - arrows - when doing this.





- Secure aligned sensor - 1 - with right hand, remove adhesive tape strips - 2 - and affix sensor to padding.

- Press wiring harness in rear area into padding opening - arrow -.

- Connect wiring harness with vehicle electrical system.





Installing of remaining components is reverse of removal.

- After installing, perform a function check with ignition on.