Round Connector Systems

Round Connector Systems

• If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to => [ Secondary Lock ] Secondary Lock.

- Guide the release tool which fits the terminal housing into release channel on terminal housing.






- Grasp contact at wire and push it gently into terminal housing - arrow -.

• By pushing the contact in the direction of the terminal housing, the contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.

- At the same time, push release tool in direction of terminal housing - arrow - and pull the released contact out of terminal housing.

- After removing the contact, release tool can be pulled out of terminal housing again.