ISOFIX Mounting Child Seat, Rear

ISOFIX mounting child seat, rear





















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






ISOFIX mounting child seat, rear seat

Note! The following text describes how to install the ISOFIX mounting on the left-hand side, it can, however, also be installed on the right-hand side of the rear seat in the corresponding way.

Steps 1-6 apply to the S40 (04-) and V50




- Fold the left-hand seat cushion and rear seat backrest forward.




- Grasp the upper edge of the left-hand side cushion A. Pull the side cushion forward so that the clips on the reverse release.
- Remove the side cushion by sliding it upwards.




- Remove the screw for the left-hand rear backrest mounting in the body. Fold up the bracket over the mounting in the backrest.
- Lift up the free end of the backrest and pull it off from the right.
- Position the backrest behind the backrest of the front seats.




- Pull off the rear edge of the floor carpet from the floor support. Fold the carpet to one side to expose the attachment points for the ISOFIX mounting in the floor.
- Remove the screws from the support bracket, new screws are in the kit.
- Remove the cover plug from the floor, it will no longer be used.




- Install the ISOFIX mounting, from the kit, over the weld nuts. Tighten the mounting using the two screws. Tighten to 40 Nm (30 lbf.ft.).




- Fold the floor carpet back into place and insert the ISOFIX mounting's eyelets in the two cut-outs. Insert the rear edge of the floor carpet under the floor support. If necessary, pry up the floor support to make room.
- Reinstall the backrest. Tighten the screws to 40 Nm (30 lbf.ft).
- Reinstall the side bolster.
- Fold the seat cushion back into place.

Steps 7-19 apply to the C30




- Pull off the seat cushion, first at the rear edge where it is secured by one holder. Then at the front edge where it is secured by two holders.
- Remove the seat cushion.




- Fold the central arm rest forward.
- Remove the central arm rest by grasping each end and pulling upwards until it releases at the rear edge from the backrest's lugs (1).
- Then pull forwards until the holders (2) on the sides of the backrest have slid out of the corresponding cut-out (3) in the central arm rest.




- Fold the backrest forward.
- Remove the panel for the backrest's left-hand mounting.








- Fold the backrest away from the left-hand mounting.
- Pull it out from the mounting at the armrest and remove it.




- Insert the mounting under the insulation panel and move the brackets up in the slots in the insulation panel




- Take the two screws from the kit. Tighten the mounting. Tighten to 40 Nm (30 lbf. ft.).




- Reinstall the backrest. Check that it is securely in its mountings.




- Secure the backrest in the left-hand mounting with the screw and lock pin.
- Tighten the backrest and check that it is securely in its mountings. Torque tighten the screw to 25 Nm (18.5 lbf.ft.).












- Reinstall the central arm rest by grasping each end, moving it up towards the backrest lugs (1) and aligning the holders (2) in the backrest's sides in the central arm rest's cut-out (3).
- Then press the central armrest down at the rear edge so that the lugs (1) engage in the cut-out (4). A click should be heard when the central armrest is secured.