Signal Too Low

Signal too low

Checking the connectors
Check the control module and roof lamp module connectors. Check for contact resistance and oxidation.

Other information:
- To access the roof lamp module connector, see Replacing interior lighting Service and Repair
- To access the connector for the upper electronic module (UEM), see Upper electronic module (UEM) rear view / door mirror, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals.









Was a fault detected?

Yes - Verification

No - Checking for open-circuits and short-circuits

-------------------------------------------------

Checking for open-circuits and short-circuits
Check the cable between the control module terminal #19 and roof lamp module terminal #5A. Check for an open-circuit. Check for a short-circuit to ground.
Replace the cable if a fault is found.
Try new bulbs in the roof lamp module if no fault is found.

Other information:
- For further information about signals and other values, see Signal specification Signal Specification, Upper Electronic Module (UEM)
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To replace bulbs in the roof lamp module, see Replacing interior lighting Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals.










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that the relevant lamp button and lamp are functioning.

Does the lamp function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Checking the connectors

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------