Tilt Sensor

Tilt sensor



















Tilt sensor

Note! This accessory is connected to the car's electrical system. It requires software unique to the car.

Applies to the S60/S80

Preparations




- Turn the knob (1) on the left-hand rear panel through 90°
- Fold the panel (2) inwards.

Installation




- Disconnect the pre-routed green (GN) connector (1), taped on the cable harness under the fuse holder. Connect the connector to the tilt sensor (2)
- Install the tilt sensor on the bracket (3)
- Reinstall the side panel in the cargo compartment. Reinstall the carpet in the cargo compartment. See procedure Tilt sensor Tilt Sensor.

Only applies to the V70 (00-)

Preparations




- Remove the left foldable panel in the cargo compartment.

Installation




- Disconnect the pre-routed green (GN) connector (1), taped on the cable harness under the fuse holder. Connect the connector to the tilt sensor (2)
- Install the tilt sensor on the bracket (3)
- Reinstall the foldable panel.

Applies to all models

- Program the software according to the service information in VIDA.