ISOFIX Mounting Child Seat, Rear Seat

Isofix mounting child seat, rear seat



















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Isofix mounting child seat, rear seat

Note! The following text describes the installation of the Isofix mounting on the left-hand side. However installation on the right-hand side of the rear seat is also possible.




- Fold forward the left-hand seat cushion and backrest in the rear seat.




- Grasp the upper edge of the left-hand side cushion. Pull the side cushion forward so that the clips on the reverse release
- Remove the side cushion by sliding it up.




- Remove the screw for the mounting in the chassis for the left-hand rear backrest. Fold up the bracket over the mounting in the backrest
- Lift up the free end of the backrest and pull it off from the right
- Position the backrest behind the front seat backrest.




- Pull the rear edge of the floor carpet off the floor support. Fold back the carpet to expose the mounting points for the Isofix mounting in the floor
- Remove the screw from the support bracket. There is a new screw in the kit
- Remove the blind cover plug in the floor, it will not be used again.




- Install the ISOFIX mounting from the kit over the welded nuts. Tighten the mounting using the two screws. Tighten to 40 Nm (30 lbf. ft.).




- Fold the floor carpet back into place. Insert the ISOFIX mounting eyelets in the two cut-outs. Insert the rear edge of the floor carpet under the floor support. Carefully pry up the floor support if necessary to get it into place
- Move the backrest back into place. Tighten the screw. Tighten to 40 Nm (30 lbf. ft.)
- Reinstall the side cushion
- Fold the seat cushion back into place.