Components on the Outer Constant Velocity Joint Housing, Replacing

Components on the outer constant velocity joint housing, replacing
Removing the outer ring, bearing race and inner ring of the outer constant velocity joint housing





Mark components in relation to each other. Use an electric scriber.

Removing the balls





Turn the inner ring and bearing race of the constant velocity joint housing. Remove the ball bearings clockwise one by one.
Use the marking as the starting point when removing.
Place the ball bearings in order so that they can be reinstalled in the same positions.

Removing the bearing race and inner ring from the shaft





Turn the inner ring 90 degrees in relation to the bearing race. Remove the inner ring.

Cleaning the components on the outer constant velocity joint housing





Clean the components of the outer constant velocity joint housing thoroughly.

Note: Replace the drive shaft assembly if any component has cracking or wear damage. Scratches and minor pitting of the bearing races are permitted.

Installing the inner ring in the bearing race Install the inner ring in the bearing race.





Line up the markings with each other. Install a ball bearing.

Note: Take care when installing the inner ball bearings.

Turn the inner ring and the bearing race. Install the ball bearings one by one in the same positions as before.

Installing boot and drive shafts
Before installing the boot, see: Installation preparations.
Install the drive shafts.