Alternator Brush: Service and Repair

Carbon brush set

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the carbon brush set





Remove:
- the generator. Service and Repair
- the 3 M6 nuts on the cover
- the cover
- the 2 M4 screws for the carbon brush set
- the carbon brush set.





Installation

Note! For tightening torques, see Specifications. [1][2]Specifications

Installing the carbon brush set





Hint: In order to keep the brushes out when installing, press out the brushes using a finger. Then insert a 1.5 mm Allen key in the hole on the top of the brush holder.

Install:
- the carbon brush set.
- the 2 M4 screws for the carbon brush set
- the cover
- the 3 M6 nuts on the cover
- the generator (GEN). Service and Repair