Front Passenger's Power Window Motor Test

Front Passenger's Power Window Motor Test

Motor Test

1. Remove the front passenger's power window switch. Front Passenger's Power Window Switch Replacement

2. Test the motor in each direction by connecting battery power and ground to the front passenger's power window switch 37P connector (A) according to the table.

3. If the motor does not run or fails to run smoothly, go to step 4, if the motor runs smoothly, go to step 8.

4. Remove the door panel. Front Door Panel Removal/Installation











5. Disconnect the 6P connector (A) from the front passenger's power window motor (B).






6. Check for continuity between front passenger's power window switch 37P connector terminals No. 12 and No. 24, and front passenger's power window motor 6P connector terminals No. 1 and No. 4 respectively. There should be continuity.





7. If there is no continuity, repair an open in the wire(s). If the wire harness is OK, replace the front passenger's power window motor.






Hall IC Unit (Pulsar) Test

8. Do the front passenger's power window switch input test terminals No 26, No. 27, and No. 28.. Front Passenger's Power Window Switch Input Test