Power Brake Booster Vacuum Rear Pipe Replacement

Power Brake Booster Vacuum Rear Pipe Replacement (2.4L)

Removal Procedure

1. Turn the ignition OFF.

2. Apply the brake pedal several times until the brake pedal becomes firm to deplete the power vacuum brake booster vacuum reserve.





3. Disconnect the power brake booster vacuum pipe quick connect (1).





4. Disconnect the power brake booster vacuum sensor electrical connector.

5. Release the power brake booster vacuum rear pipe from the retainer (1) on the dash panel.

6. Remove the power brake booster vacuum rear pipe vacuum sensor and check valve (2) from the power vacuum brake booster.





7. Remove the power brake booster vacuum rear pipe from the retainers (1) on the dash panel.

8. Release the power brake booster vacuum rear pipe from the retainer (2) on the right front brake pipe.

9. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

10. Remove the right front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement .





11. Release the power brake booster vacuum rear pipe retainer (1) from the power brake booster pump bracket.

12. Disconnect the power brake booster vacuum rear pipe quick connect (2).

13. Remove the power brake booster vacuum rear pipe from the vehicle.

Installation Procedure





1. Position the power brake booster vacuum rear pipe to the vehicle.

2. Install the power brake booster vacuum rear pipe retainer (1) to the power brake booster pump bracket.

3. Connect the power brake booster vacuum rear pipe quick connect (2).

4. Install the right front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement .





5. Install the power brake booster vacuum rear pipe to the retainers (1) on the dash panel.

6. Install the power brake booster vacuum rear pipe to the retainer (2) on the right front brake pipe.





7. Install the power brake booster vacuum rear pipe to the retainer (1) on the dash panel.

8. Install the power brake booster vacuum rear pipe vacuum sensor and check valve (2) to the power vacuum brake booster.

9. Connect the power brake booster vacuum sensor electrical connector.





10. Connect the power brake booster vacuum pipe quick connect (1).