Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure





1. Remove the instrument panel (I/P) cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Service and Repair) .
2. Remove the I/P cluster screws.
3. Remove the I/P cluster.
4. Remove the I/P cluster wire harness connector.



Installation Procedure





1. Install the I/P cluster wire harness connector.
2. Install the I/P cluster.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Tighten the I/P cluster screws.

Tighten the screws to 2.5 N.m (22 lb in).

4. Install the I/P cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Service and Repair) .
5. Refer to Control Module References (Programming and Relearning) for programming and setup information.