Rear Door Window Regulator: Service and Repair

Rear Side Door Window Regulator Replacement

Removal Procedure





1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Service and Repair) .
2. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair) .
3. Raise the rear door window far enough in order to gain access through the inner door to the window to the window peg retainer. Refer to Rear Side Door Window Replacement (Rear Side Door Window Replacement) .
4. Remove the nylon peg from the rear door window to regulator.
5. Raise the rear door window to the full up position.
6. Tape the rear door window in the full up position.
7. Disconnect the electrical connector.




8. Remove the bolts from the rear door window regulator (1).
9. Remove the rear door window regulator from the rear door.



Installation Procedure





1. Install the rear door window regulator to the door.





Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the regulator mounting bolts (1).

Tighten the rear door window regulator bolts to 10 N.m (89 lb in).

3. Connect the electrical connector.
4. Remove the tape from the rear door window.
5. Lower the rear door window far enough to install the door window. Refer to Rear Side Door Window Replacement (Rear Side Door Window Replacement) .
6. Install the bolts to the rear door window regulator (1, 2).

Tighten the window regulator bolts to 10 N.m (89 lb in).

7. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair) .
8. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Service and Repair) .