Windshield Wiper Arm Replacement

Windshield Wiper Arm Replacement

Tools Required

J 39637 Wiper Arm Removal Tool


Removal Procedure





1. Ensure that the wiper arms are set to the PARK position.
2. Open the hood.




3. Disconnect the washer hose connectors from the air inlet grille panel.
4. Remove the wiper arm nut finish cap.
5. Remove the wiper arm nut.




6. Using J 39637 , remove the wiper arm from the wiper pivot shaft.



Installation Procedure


Important: The wiper arm nut must be hand-started to avoid cross-threading.






1. Install the wiper arm onto the wiper module pivot shaft.
2. Align the wiper blade to the wiper dots on the windshield.





Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the wiper arm nut. Hold the wiper arm to the wiper dot as you tighten the nut.

Tighten the nut to 35 N.m (25 lb ft).

4. Install the wiper arm nut finish cap.




5. Connect the wiper arm washer hose connectors to the air inlet grille panel.
6. Operate the windshield wipers and inspect for proper operation.
7. Close the hood.