Alternator: Service and Repair

Generator Replacement (1.4L LDD, LUH, and LUJ)

Removal Procedure

1. Open the hood.
2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without Start/Stop System) Battery Negative Cable Disconnection and Connection (without Start/Stop System).
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.




4. Disconnect the generator wiring harness connector (3).
5. Remove the generator positive cable nut (1).
6. Remove the generator positive cable (2).
7. Lower the vehicle.
8. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement Service and Repair.




9. Remove the 2 generator bolts (2).
10. Remove the generator (1) from above.

Installation Procedure




1. Install the generator (1) from above.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the 2 generator bolts (2) and tighten to 35 Nm (26 lb ft).
3. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement Service and Repair.
4. Raise and support the vehicle.




5. Connect the generator wiring harness connector (3).
6. Install the generator positive cable (2).
7. Install the generator positive cable nut (1) and tighten to 17 Nm (13 lb ft).
8. Lower the vehicle.
9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without Start/Stop System) Battery Negative Cable Disconnection and Connection (without Start/Stop System).
10. Close the hood.