Front Bumper Fascia Removal and Installation

Front Bumper Fascia Removal and Installation











2.Remove the front compartment front sight shield. Refer to Front Compartment Front Sight Shield Replacement .

3.Remove the windshield washer solvent container filler tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement .

4.Remove the side four front screws from the front wheelhouse liners. Refer to Front Wheelhouse Front Liner Replacement Front Wheelhouse Front Liner Replacement .

1Front Bumper Fascia Upper Push-In Retainer (Qty: 2)

2Front Bumper Fascia Upper Screw (Qty: 4)
Caution:Refer to Fastener Caution .
Tighten 3 N �m (27 lb in)

3Front Bumper Fascia Lower Screw (Qty: 2)Tighten 3 N �m (27 lb in)

4Front Bumper Fascia Lower Push-In Retainer (Qty: 4)

5Front Bumper Fascia

Procedure

1.Carefully push a small nylon wedge between the fascia and the front fascia retainers. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia retainers of the fender.

2.Disconnect any electrical connectors.

3.Transfer any parts as needed.