Sunroof / Moonroof Panel: Adjustments

Sunroof Window Height and Opening Fit Adjustment

1. Remove the sunroof panel side opening closeout covers. Refer to Sunroof Panel Side Opening Closeout Cover Replacement Sunroof Panel Side Opening Closeout Cover Replacement.

Note:
Correct adjustment cannot be achieved if the sunroof window is closed from vent position.

2. Cycle the sunroof window from full open to closed position.





Note:
Do Not remove or lower headliner to access sunroof window screws.

3. Loosen the adjusting screws on the window.

4. Adjust the corners of the front window panel using the following guidelines:

* Adjust the front of the sunroof window to 0.0 mm-1.0 mm (0.0 in-0.04 in ) below the top surface of the roof panel.

* Adjust the rear center line of the sunroof window to 2 mm-3 mm (0.08 in-0.12 in) below the top surface of the roof panel.

Caution:
Refer to Fastener Caution Fastener Caution.

5. Tighten the sunroof window adjustment screws to 5 Nm (44 lb in).

6. Cycle sunroof window through all positions.

7. Inspect the sunroof window adjustment. Adjust if necessary.

8. Install the sunroof panel side opening closeout covers. Refer to Sunroof Panel Side Opening Closeout Cover Replacement Sunroof Panel Side Opening Closeout Cover Replacement.