Parking Brake Release Handle Assembly Replacement

Parking Brake Release Handle Assembly Replacement

Removal Procedure

1. Disconnect the release cable from the brake lever.

2. Disconnect the cable from the retainer on the brake lever.

3. Remove the park brake release lever handle mounting bolt.





4. Remove the release handle from the instrument panel retainer.

5. Remove the release handle and cable from the vehicle. Note the routing of the cable as you remove the park release handle assembly from the vehicle.

Installation Procedure





1. Install the release handle and the cable to the vehicle. Install the cable using the same routing as the original cable.

2. Install the release handle to the instrument panel retainer.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the park brake release lever handle mounting bolt and tighten to 10 Nm (89 lb in).

4. Connect the cable to the retainer on the brake lever.

5. Connect the release cable to the lever.