Rear Output Shaft Seal Replacement

Rear Output Shaft Seal Replacement

Special Tools

J 45756 - Output Shaft Seal Installer

For equivalent regional tools, refer to Special Tools BW 4485-NR3 - Transfer Case.

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement Transfer Case Shield Replacement.

3. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement Rear Propeller Shaft Replacement.

4. Remove the rear output shaft seal by prying it out with a flat-bladed tool.

Installation Procedure




1. Using the J 45756 - installer, install a NEW front output shaft seal.

2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement Rear Propeller Shaft Replacement.

3. Check the fluid level. Add fluid, if necessary.

4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement Transfer Case Shield Replacement.

5. Lower the vehicle.