Parking Brake Cable - Installation

INSTALLATION





1. Install the parking brake cable through the eyelets.
2. Attach the parking brake cable (2) to the rear wheel carrier assembly (4) by installing the mounting bolt (1). Tighten to 20 Nm (15 ft. lbs.).
3. Push the cable pin through the arm (3) attaching the actuator to the cable (2).
4. Close the actuator arm top cover (3) encasing the cable pin.
5. Install the actuator arm (3) to the rear wheel carrier assembly (4) ensuring the actuator rests on the brass pins and it is not binding.




6. Install the parking brake cables (2) to the parking brake cable equalizer.
7. Install the parking brake cable equalizer to the front parking brake cable mounting bolt (5).




8. Install the parking brake shoe assembly (1-5). Installation.




9. Install the rear brake rotor (1). Brake Rotor - Installation.




10. Install the rear caliper assembly bolts (1). Disc Brake Caliper - Installation.
11. Adjust the parking brakes. Adjustments.
12. Install the wheel and tire assembly. Procedures.
13. Lower vehicle and verify parking brake operation. If parking brakes need to be adjusted. Adjustments.