Inspection

INSPECTION

DISASSEMBLING





1. Before disassembling the C/V joint assembly, mark the positions of joint ring, joint hub and the bearing cage with a suitable marking tool (1).




2. Rotate the bearing cage inside of the joint hub (arrow) and remove the bearing balls one at a time.
3. Remove the joint hub and the bearing cage from the joint ring.




4. Pivot the joint hub 90° relative to the bearing cage and remove it from the assembly.
5. Thoroughly clean all the parts.

INSPECTION





1. Inspect the roller tracks in the C/V joint housing (1), bearing cage (2), and joint hub (4). Inspect the bearing balls (3) for signs of pitting or wear.
2. If these parts are extremely worn, the entire C/V joint must be replaced. Smooth areas and tracks caused by the ball bearings are no reason to replace the C/V joint.

ASSEMBLING





1. Hold the joint hub vertically relative to the bearing cage, then guide it into place.




2. Insert one bearing ball, paying attention to the alignment marks on the joint hub and bearing cage.
3. Insert the joint hub with the bearing cage and the bearing ball in the joint ring while ensuring that the markings are properly aligned.




4. Tilt the joint hub out with the bearing cage to allow the bearing balls to be inserted one after the other.
5. The C/V joint is now ready to be installed on the halfshaft.