Instrument Panel Ash Receiver - Removal

REMOVAL





1. Disconnect and isolate the negative battery cable.
2. Remove the gear shift center bezel from the floor console (4) Floor Console - Removal.
3. Set the emergency brake and place the gear shift lever into Low gear.
4. Using a trim stick C-4755 or equivalent (1), remove the ash receiver (2) from the instrument panel (3) by releasing the snap retainers from the instrument panel.





5. If equipped, disconnect the wire harness connectors (2) from the heated seat switches and remove the switches as required. Heated Seat Switch - Removal
6. Disconnect the wire harness connector (3) from the lighter and remove the lighter assembly as required.
7. Remove the ash receiver from the vehicle.