Diesel Data: Automotive Repair
Home >> Dodge >> 2009 >> Charger V6-2.7L >> Repair and Diagnosis >> Body and Frame >> Bumper >> Front Bumper >> Front Bumper Cover / Fascia >> Service and Repair >> Front Bumper Fascia - Installation

Front Bumper Fascia - Installation






INSTALLATION





1. If removed, install the push-pin retainer (2) and a new nut insert (1) into each front fender.

NOTE: 300 Shown. Magnum and SRT8 similar.





2. If removed on SRT8 models, install the lower fascia onto the front fascia assembly (4) using new metal retaining clips.
3. If equipped and removed, install the fog lamps onto the front fascia assembly Fog Lamp - Installation.
4. Position the front fascia assembly to the vehicle and connect each fog lamp wire harness connector (3), if equipped.
5. If equipped, connect the headlamp washer system hose to washer reservoir.Headlamp Washer Nozzle - Installation
6. On all three SRT8 models, connect the Tire Pressure Monitoring connector Tire Pressure Monitoring (TPM) Module - Installation.
7. Engage the push-pin retainer (6) into the slot in each side of the front fascia assembly by pushing the fascia rearward.
8. Install the push-pin retainers (2) (four-sedan, six-wagon, eight Charger) that secure the front fascia assembly to the upper radiator support.
9. Raise and support the vehicle.
10. Install the screw (5) that secures the front fascia assembly to the nut insert (1) in each front fender. Tighten the screws securely.
11. Position belly pan to front of vehicle. Install and tighten screws.






NOTE: Charger vehicles only.

12. Install the screw (6) that secures the front fascia assembly (5) to the nut insert (1) in each front fender.
13. Partially lower the vehicle and install the push-pin retainers (4) (four-sedan, six-wagon, eight-Charger) that secure the front fascia assembly to the upper radiator support.
14. Carefully pull the front fascia assembly rearward to engage the fastener (6) from the slot in each side the fascia and position the fascia to gain access to the fog lamp wire harness connectors (7), if equipped.





15. Position the belly pan (2) to the front of the vehicle underbody and install the nine screws (1). Tighten the screws securely.





16. Position each front wheel house splash shield (2) to the front fascia assembly (3) and install the push-pin retainers (1).
17. Lower the vehicle.
18. If equipped with ACC (Adaptive Cruise Control), module must be realigned. Adjustments

Diesel-Data.com