Power Steering Pump - Installation

2.7L/3.5L





1. Align pump (3) with mounting holes on engine bracket (2).
2. Install three pump mounting bolts (1) through access holes in pulley and engine bracket. Tighten bolts to 28 Nm (21 ft. lbs.) torque.






NOTE: Always use a NEW O-ring on the end of the pressure hose.

3. Lubricate NEW O-ring on end of pressure hose with clean power steering fluid.
4. Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.) torque.





5. Install supply hose (3) on pump. Install clamp (2) securing hose in place.
6. Install serpentine drive belt. Serpentine Accessory Drive Belt - Installation
7. Install air cleaner housing and inlet tube. Air Cleaner Body - Installation





8. Connect battery negative cable (2) to battery post. It is important that this is performed properly. Battery Reconnection
9. Fill and bleed power steering system. Power Steering System Bleeding