Front Bumper Fascia - Installation

INSTALLATION






NOTE: Base model shown, other models typical unless noted.

1. If replacing the lower air dam, carefully align the air dam, starting on one side and working across, install the box staples securing it to the fascia.
2. Position the fascia (1) to the vehicle.
3. Align and position the fascia to fender retaining tabs.
4. Push in on the fascia sides at the fender to engage the retaining tabs.





5. Install the four fasteners (1) securing the fascia to the upper radiator support. Tighten the fasteners securely.





6. Raise and support the vehicle.
7. Install the two outboard fasteners (1) located at the bottom of fascia. Tighten the fasteners securely.
8. Install the three middle fasteners (2) located at the bottom of the fascia. Tighten the fasteners securely.





9. Peel back the splash shield and install the fender to fascia fastener (1). Tighten the fastener securely. Repeat on the opposite side.





10. Open the access door (2) located on the splash shield and connect the fog/park lights and the sidemarker lamp. Repeat on the opposite side.
11. Install the splash shield to fascia fasteners (1). Tighten the fasteners securely. Repeat on the opposite side.
12. Lower the vehicle.
13. Connect the negative battery cable.