Front Bumper Fascia - Removal

REMOVAL






NOTE: Base model shown, other models typical unless noted.

1. Open the hood.
2. Disconnect the negative battery cable.
3. Remove the four fasteners (1) securing the fascia to the upper radiator support.





4. Raise and support the vehicle.
5. Open the access door (2) located on the splash shield and disconnect the fog/park lights and the sidemarker lamp. Repeat on the opposite side.
6. Remove the splash shield to fascia fasteners (1). Repeat on the opposite side.





7. Peel back the splash shield and remove the fender to fascia fastener (1). Repeat on the opposite side.





8. Remove the two outboard fasteners (1) located at the bottom of fascia.
9. Remove the three middle fasteners (2) located at the bottom of the fascia.





10. Lower the vehicle.
11. Pull out on the fascia sides at the fender to disengage the retaining tabs.
12. Carefully, remove fascia (1) from the vehicle.
13. If replacing the lower air dam, carefully remove the box staples securing it to the fascia one at a time before removing the air dam. Do not pull/rip the air dam off with the staples installed.