Test C: The CHECK FUEL CAP Message Is Inoperative/Always On

PINPOINT TEST C: THE CHECK FUEL CAP MESSAGE IS INOPERATIVE/ALWAYS ON

Normal Operation
The PCM monitors the fuel tank evaporative emission system for significant leaks that occur following refueling of the vehicle. Once the PCM detects a fuel vapor leak, the PCM sends the instrument cluster (IC) a message over the communication network to turn on the CHECK FUEL CAP message. DTC P0457 sets in the PCM following a successful cruise test, which is initiated when the vehicle is driven at a steady speed above 64 km/h (40 mph) for a duration of approximately 4-5 minutes. If the PCM is unable to successfully run the cruise test, the instrument cluster (IC) does not receive the check fuel cap message and the CHECK FUEL CAP message remains off.

- DTC P0457 (Evaporative Emission System Leak Detected [fuel cap loose/off]) - sets in the PCM if a fuel tank pressure change greater than -23.7 kPa (-7 in-Hg) of vacuum within 30 seconds after refueling occurs, or there is an excessive purge (fuel vapor) flow of greater than 454 g (1.0 lb) per minute.

This pinpoint test is intended to diagnose the following:
- PCM
- Instrument cluster (IC)

C1-C2:

C3: