Washer Pump and Reservoir

Washer Pump and Reservoir





Removal and Installation

1. Remove the washer fluid reservoir filler neck bolt.





2. Position aside the coolant overflow bottle.
- Remove the 2 bolts and position the coolant overflow bottle aside.

3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

4. Remove the radiator lower air deflector.

5. Disconnect the washer pump electrical connector.

6. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.

Disconnect the washer pump hose. For additional information, refer to C-Lock Coupler Service and Repair.

7. Remove the windshield reservoir.
- Remove the nut and 2 bolts.
- To install, tighten to 5 Nm (44 lb-in).

8. NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.

To install, reverse the removal procedure.