Diesel Data: Automotive Repair

Removal and Replacement




Clutch Slave Cylinder

Removal

1. Remove the transaxle. For additional information, refer to Manual Transaxle/Transmission Removal and Replacement.

2. NOTICE: If brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Any oily or greasy deposits witnessed on the slave cylinder release bearing surface should be wiped off with a suitable de-greasing agent or cleaner. Do not use detergent or other corrosive agents.

Remove the 3 clutch slave cylinder bolts and remove the clutch slave cylinder.





Installation

1. NOTICE: If brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Install the clutch slave cylinder and the 3 clutch slave cylinder bolts.

- Tighten to 11 Nm (97 lb-in.).





2. Install the transaxle. For additional information, refer to Manual Transaxle/Transmission Removal and Replacement.

3. Fill and bleed the clutch system. For additional information, refer to Manual Transaxle/Transmission and Clutch - General Information Service and Repair.