Removal and Replacement

Throttle Body Removal/Installation

CAUTION
Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.

NOTE: If you are replacing the throttle body, start at step 1 Removal and Replacement. If you are removing the throttle body, start at step 4 Removal and Replacement.

1. Connect the HDS to the data link connector (DLC) while the engine is stopped.

2. Select the INSPECTION MENU on the HDS.

3. Do the TP POSITION CHECK in the ETCS TEST.

4. Turn the ignition switch to LOCK (0).

5. Remove the intake air duct (A).





6. Disconnect the throttle body connector (B) and the vacuum hose (C).

7. Disconnect and plug the water bypass hoses (D).

8. Remove the throttle body (E).

9. Install the parts in the reverse order of removal with a new gasket (E).

NOTE:

- When tightening the screw of the hose band (F), align the edge (G) of the hose band with the mark (H) painted on the hose band. If you tighten the screw over the mark, replace the hose band.
- Do the PCM idle learn procedure. PCM Idle Learn Procedure

10. Refill the radiator with engine coolant Service and Repair.