System Always Comes Up In The In-Line Diagnostic Mode (Factory Diag Mode) (10 Model)

Navigation System Symptom Troubleshooting - System always comes up in the in-line diagnostic mode (Factory Diag Mode) ('10 model)

System always comes up in the in-line diagnostic mode (Factory Diag Mode)

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- Check the connectors for poor connections or loose terminals.
- You may also see this screen if a new or remanufactured audio-navigation unit is installed.

1. When an audio-navigation unit is powered up for the first time at the factory, the factory diagnosis screen (In Line Diag) appears. Normally the factory does the steps necessary to verify proper operation and terminate the factory diagnostic. Until the proper confirmation sequence is done, the screen appears every time the vehicle is started.






2. Follow the steps to prevent the screen from showing up in the future:

- Hold down the MENU, Map/Guide, and Cancel buttons for about 5 seconds (the Select Diagnosis Items screen appears).
- Hold down the Map/Guide button for 5-10 seconds (A screen with a Complete button appears).
- Touch Complete.
- Touch the Return button twice (the system may reboot).
- Restart the vehicle, and confirm normal operation by completing the PDI of the navigation system Service Bulletin.