Drivers Vent Panel Removal/Installation

Driver's Vent Panel Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the dashboard or the related parts.

1. Remove the driver's vent panel (A).

1. Apply protective tape (B) to the dashboard side panel (C) next to the driver's vent panel. Pry out the front left side of the panel partially with the appropriate trim tool.

2. Pry the front bottom of the panel slightly toward you.





2. Pull back the bottom portion of the driver's vent panel (A) slightly toward you to detach the clips (B). Detach the clips (C) by pulling the middle and upper portions of the panel toward you by hand.





3. Disconnect the power mirror switch connector (D) and VSA OFF switch connector (E), then if necessary, remove the switch (F) from the panel.

4. If necessary, remove the screws, then remove the driver's vent (A) from the driver's vent panel (B).






5. Install the panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure each connector is plugged in properly.