Passengers Vent Panel Removal/Installation

Passenger's Vent Panel Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the dashboard or the related parts.

1. Open the passenger's tray lid.

2. Remove the passenger's vent panel (A).

1. From the tray lid opening, pull out the left side edge of the panel by hand.

2. Pry out the front bottom of the panel slightly toward you to detach the lower clips.





3. Pull out the bottom portion of the passenger's vent panel (A) partially by hand. Detach the upper clips by pulling the middle and upper portions of the panel toward you.






4. If necessary, remove the screws, then remove the passenger's vent (A) from the passenger's vent panel (B).





5. Install the panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.