83-22

SRS DTC Troubleshooting: 83-22

DTC 83-22:

No Signal From the Outer Side Front Passenger's Weight Sensor

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the DTC memory.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Read the DTC.

Is DTC 83-22 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�

4. Turn the ignition switch to LOCK (0).

5. Disconnect the ODS unit harness 3P connector from the front passenger's weight sensor (outer side) Service and Repair.

6. Turn the ignition switch to ON (II), then wait for 10 seconds.

7. Measure the voltage between ODS unit harness 3P connector terminals No. 1 and No. 3. There should be more than 6 V.





Is the voltage as specified?

YES -

Faulty front passenger's weight sensor (outer side); replace the outer side front passenger's weight sensor Service and Repair, then clear the DTC.�

NO -

Open in the ODS unit harness; replace the ODS unit harness, then clear the DTC, and retest. If the DTC is still present, replace the ODS unit ODS Unit Replacement.�