Center Console Removal/Installation (SC)

Center Console Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

SC Model

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the center console, the dashboard, or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Push in where indicated to release the hook (A) on the beverage holder (B), then remove the holder.






2. Pull the parking brake lever.

3. Remove the center console front panel (A).

1. Remove the front panel mat (B).

2. Pull up the rear edge of the panel to detach the clips (C) and release the hook (D).

3. Pull the panel backward to detach the clips (E).





4. Remove the center console rear panel (A).

1. Remove the bolt (B) from the bottom of the panel.

2. Open the armrest, gently pull up the edge of the panel to detach the clips (C, D) and release the hooks (E).

3. Remove the panel by pulling it up and over the parking brake lever.





5. Disconnect the console accessory power socket connector (A) from the bottom of the center console. Remove the bolts (B, C).






6. Remove the console box mat (A), then remove the bolts.






7. Gently lift up the rear of the center console (A), and pull it backward to release the pins (B) and detach the clips from the dashboard, then remove the console.






8. Remove the center floor tray (A).

1. Remove the center floor tray mat (B).

2. Pull up the rear edge of the tray to detach the clips (C).

3. Pull the tray backward to detach the clips (D).





9. Install the console in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips and the hooks into place securely.