Diesel Data: Automotive Repair
Home >> Honda Truck >> 2010 >> Element 2WD L4-2.4L >> Repair and Diagnosis >> Sensors and Switches >> Sensors and Switches - Restraints and Safety Systems >> Impact Sensor >> Service and Repair >> Side Impact Sensor (First) Replacement

Side Impact Sensor (First) Replacement




Side Impact Sensor (First) Replacement

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front seat Front Seat Removal/Installation.

3. Remove the front door sill trim Service and Repair.

4. Disconnect the floor wire harness 2P connector (A) from the side impact sensor (first) (B).





5. Remove the TORX bolt (C) using a TORX T30 bit, then remove the side impact sensor (first).

Installation

1. Install the side impact sensor (first) (A) with the new TORX bolt (B), using a TORX T30 bit. Connect the floor wire harness 2P connector (C) to the side impact sensor (first).





2. Install the front door sill trim Service and Repair.

3. Reinstall the front seat Front Seat Removal/Installation.

4. Do the battery terminal reconnection procedure.

5. Clear any DTCs.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

7. Install all removed parts.

Diesel-Data.com