Tire Pressure Module: Service and Repair

TPMS Control Unit Replacement

'09-11 Models

NOTE: Make sure the TPMS control unit mounting bracket is not bent or twisted as this may affect its communication with the tire pressure sensors.

1. Turn the ignition switch to LOCK (0).

2. Remove the center panel Dashboard Center Panel Removal/Installation.

3. Remove the audio unit Audio Unit Removal/Installation (Without Navigation).

4. Disconnect the TPMS control unit connector (A).





5. Remove the TPMS control unit (B) from the bracket (C).

NOTE: To disconnect the TPMS control unit from its bracket, insert a small flat-tipped screwdriver between the TPMS control unit and the bracket shown in (D) to release the hook, then slide out the TPMS control unit.

6. Replace the bracket if necessary.

NOTE: Once the bolts is loosened apply medium strength liquid thread lock or equivalent to the bolts before reinstallation.

7. Install the TPMS control unit in the reverse order of removal.

NOTE: Make sure the TPMS control unit is properly installed. You will hear a click when the TPMS control unit is securely mounted on the bracket.

8. Connect the HDS, and memorize the pressure sensor IDs using the TPMS tool Memorizing The Tire Pressure Sensor ID.